1. Home

"(Required)" indicates required fields

This field is for validation purposes and should be left unchanged.
1. When adjusting the height of the dispensing nozzle, which is the proper adjustment?(Required)
2. When testing pump movement using service mode pump motion test, what is proper pulse count as shown on screen?(Required)
3. Using the service mode 2) adjustment>8) rack position test, what is the proper pulse count shown on screen for each of the 12 racks?(Required)
4. What is the proper filling of the pump anti-drying bottle?(Required)
5. What is the proper filling of the dispensing nozzle anti-drying bottle?(Required)
6. What is the output voltage of the Power Supply?(Required)
7. When performing the 1) Vacuum/pressure test under 6) Hardware check, with pump off and no Coverglass on suction cup what should vacuum reading be?(Required)
8. When performing the 1) Vacuum/pressure test under 6) Hardware check, with pump on and Coverglass on cup what should vacuum reading be?(Required)
9. If it is needed to check/adjust the alignment and of coverglass placement onto the slide due to visible air bubbles, which service sub-menu test under 2) Adjustment would contain the applicable adjustments?(Required)
10. If the R Arm motor (rotation of the gripper) was replaced, which of the following service mode tests would not be applicable to run/check after replacing?(Required)