1. Home

"(Required)" indicates required fields

This field is for validation purposes and should be left unchanged.
1. Embedding Center. When calibrating paraffin chamber temperature at factory default setting of 62C, what is the range that measured temperature should fall between?(Required)
2. Embedding Center. E101 (03) is repeatedly occurring. Which part is most likely cause of this error?(Required)
3. Embedding Center. Paraffin has just been cleaned from dispensing plate microswitch. Which service mode screen needs to be accessed to test unit receiving correct engaging/disengaging signals from the microswitch when depressed/released?(Required)
4. Embedding Center. Unit has been powered off for some time. User powers on and immediately states there is no illuminating lamp function/icon available on screen to activate lamp. What is likely reason for this?(Required)
5. Embedding Center. At “normal” environmental conditions (room temperature 25C, relative humidity of 40%), What temperature should the cold spot be at or below?(Required)
6. Cryo Module. When checking/calibrating cooling plate temperature at factory default setting of -5C, what range should the center (midpoint) of the high/low temperature readings fall under?(Required)
7. Cryo Module. When hooking up a cryo module to the embedding center the cryo offset value needs to be entered. The cryo offset value can be found:(Required)
8. Embedding Center. To access service mode, what is service password?(Required)
9. Embedding Center. To check individual heater readings/calibrations, which service mode screen needs to be accessed?(Required)
10. Embedding Center. Paraffin flow does not stop when dispensing push plate is released. Which would not cause this?(Required)