-Sakura Finetek USA

Name

This field is for validation purposes and should be left unchanged.

1. When the main breaker is on but the instrument is not turned on, what is needed to fully turn on the instrument in to standby mode?(Required)

A.) Turn off the breaker and turn it back on.

B.) Press the “light” button.

C.) Press any part of the touchscreen.

D.) Press the “system start” button.

2. What is the service password?(Required)

A.) 3141

B.) 314159

C.) 100000

D.) 000001

3. What is the purpose of the “Paraffin Ready” button on the monitor screen?(Required)

A.) To inform that the paraffin is ready to be melted

B.) To allow paraffin pallets to be added.

C.) To inform the paraffin temperature has reached the set point.

D.) To inform that all heaters are up to temperature and to bring the countdown timer from the 4-hour warmup, to the 1-hour warmup.

4. If the gripper arms are only physically adjusted, what should be the next step performed?(Required)

A.) Run the gripper check test to verify the gripper can pull and grab all cassettes properly.

B.) Begin running test cassettes in normal operating mode.

C.) Perform the install calibration.

D.) No action needed. The repair is completed.

5. How can you verify if the gripper is leaving and picking up cassettes properly from a basemold.(Required)

A.) Physically look at gripper to see how it leaves and picks up the cassettes in the basemold area using the gripper movement check.

B.) Verify no cassettes go to the recovery area.

C.) Making sure the embedded cassettes are picked up properly.

D.) All of the above.

6. After inputting a new value in the handy terminal for any new calibration, what is the next step?(Required)

A.) Press the apply button if applicable, and sync the data.

B.) Perform the gripper movement check.

C.) Perform the install calibration.

D.) Run test cassettes in normal operating mode.

7. What is the first step before moving the gripper?(Required)

A.) Make sure the handy terminal is connected.

B.) Verify no errors are occurring.

C.) Home the gripper first, and the stager if needed.

D.) None of the above.

8. When running test cassettes (blank), what should the threshold settings be?(Required)

A.) 15 minutes

B.) 10 minutes

C.) 5 minutes

D.) The same time the customer has set.

9. What is the proper way to connect the handy terminal?(Required)

A.) Making sure the instrument is turned on.

B.) Verify the instrument is on standby mode.

C.) Making sure the computer is turned off.

D.) Verifying the main breaker is turned off.

10. What are the last two checks on the instrument before leaving the customer location?(Required)

A.) Make sure the threshold setting is back to the original setting, and log out of the service password.

B.) Turn off the computer, and breaker after all repairs are completed.

C.) Disconnect the handy terminal if applicable, and have the customer run their cassettes.

D.) Log out of the service mode, and have the customer run their cassettes.

News

Products

Education

Customer resources

About us

MySakura

Contact us

Sitemap