1. Home

"(Required)" indicates required fields

This field is for validation purposes and should be left unchanged.
1. Embedding Center. Left Warming Chamber does not heat. Which connector should be measured for voltage and/or resistance troubleshooting?(Required)
2. Embedding Center. Unit never completes warm-up cycle, indicating a heater is not reaching set temperature. Which service mode screen is needed to access to look at heater temperature values?(Required)
3. Embedding center. Flow does not decrease at all (full force) when dispensing plate is released. What is most likely corrective action needed to resolve?(Required)
4. Embedding center. Cold spot does not cool. Replacing cold spot does not resolve. Voltage to cold spot is OK. What is likely issue that can cause this?(Required)
5. Embedding Center. During warm-up cycle, there is one heater that is purposely held at 40C until all other heaters are at set temperature. Which heater is this?(Required)
6. Cryo Module. Error W2 is displayed on embedding center. Which of the following would not cause this?(Required)
7. Embedding Center. When calibrating left warming chamber displayed temperature on test run screen shows 62C. What should thermocouple measure when properly calibrated?(Required)
8. Cryo Module. When calibrating cold plate at -5C setting, which high/low measured temperature range would indicate proper calibration?(Required)
9. Embedding Center. Paraffin chamber is not heating. Which part would not be suspect in causing this?(Required)
10. Embedding Center. Measured Cold Spot temperature at room temperature and normal humidity should be at or below which temperature?(Required)